Engine Mechanical System

Air Cleaner Repair procedures

12steps
~72min
3/5difficulty
010203040504.94N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Removal and Installation

Air Cleaner Assembly

  1. Disconnect the air duct B (A).

    Tightening torque : 2.9 - 4,9 N·m

  2. Disconnect the mass air flow sensor (MAFS) connector (A) and breather hose (B).

  3. Remove the air cleaner assembly (A).

    Tightening torque : 3.9 - 5,9 N·m

  4. Remove the air duct A (A).

    Tightening torque : 3.9 - 5,9 N·m

  5. Install in the reverse order of removal.

Air Cleaner Element Replacement

  1. Open the air cleaner element cover (A) by unlocking the clamp.

  2. Replace the air cleaner element (A) with a new one.

  3. Close the service cover by hooking the clamp.

    Close the service cover by hooking the clamp.

Inspection

  1. Remove the air cleaner element.

  2. Check if the air filter is excessively dirty. If so, replace the air cleaner element.

  3. If the air cleaner element needs to be cleaned, blow compressed air as shown in the illustration to clean it.

  4. Reinstall the air cleaner element.