Intake Manifold Repair procedures
Removal and Installation
Shut off the high voltage circuit.
(Refer to Engine Mechanical System - “High Voltage Shut off Procedure”)
Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "Air Cleaner")
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
Disconnect the wiring connectors and harness clamps and remove the wiring protector around the intake manifold.

Remove the hybrid starter generator (HSG) connector (A).

Separate the hybrid starter generator (HSG) coolant hose & pipe (A).
Tightening torque : 8.8 - 10,9 N·m

Disconnect the positive crankcase ventilation (PCV) hose (A).

Unfasten the electric throttle body control (ETC) module bolts.
(Refer to Engine Control / Fuel System - "Electric Throttle Body Control System (ETC)")
Unfasten the EGR cooler pipe C mounting nuts (A).
Tightening torque : 7.8 - 11,8 N·m

Disconnect the hybrid starter generator (HSG) high voltage cable connector (A).

Remove the intake manifold stay (A).
Tightening torque : 18.6 - 24 N·m

Remove the intake manifold (A) with the gasket.
Tightening torque : 18.6 - 24 N·m

Install in the reverse order of removal.