Engine Mechanical System
Exhaust Heat Recovery System(EHRS) Troubleshooting
In this manual: Engine Mechanical System
~2min read
Troubleshooting
| Symptom | Inspection | Remedy | ||
| Overheating | • Engine overheating • Temperature gauge rising to HI |
• Inspect GDS/KDS scanner. | ① Check DTC code. ② By using KDS/GDS, check for current flowing in wiring connecting to WTS. |
Additionally inspect wiring and connector. |
| • Inspect coolant leakage. | Inspect leakage from EHRS and coolant tube (including WTS assembly). (Visually check for signs of efflorescence after evaporation of coolant.) | For unit failure, replace EHRS and coolant tube. | ||
| • Inspect operation of EHRS valve (vehicle inspection). | Drive until the engine coolant is sufficiently warmed up, and then inspect operation of wax actuator.[Visually check the lifting amount of wax actuator: Over 8 mm (0.315 in.) at 80 °C, or over 9 mm (0.354 in.) at 90 °C. (194°F)] |
For unit failure, replace EHRS. | ||
| • Inspect operation of EHRS valve (unit inspection). | ① Remove the wax actuator. ② Rotate the valve lever to check for smooth operation. ![]() |
For unit failure, replace EHRS. | ||
| Symptom | Inspection | Remedy | ||
| Overheating | • Engine overheating • Temperature gauge rising to HI |
• Inspect operation of wax actuator. | ① Remove the wax actuator. ② Immerse wax actuator in water and gradually heat the water. ③ Inspect the opening temperature and forward stroke of the valve. [Opening temperature: 71 ± 2 °C, Forward stroke : at 80 °C 8.85 ± 0.65 mm (0.348 ± 0.026 in.] ![]() |
For unit failure, replace EHRS. |
| • Inspect WTS. | ① Remove the WTS. [Disconnect connector (a). → Remove clip (b).] ② Immerse temperature detector of WTS in water and gradually heat the water. ③ Check the resistance according to temperature. [20 °C : 2.45 ± 0.14 kΩ, 110 °C : 0.1471 ± 0.002 kΩ] ![]() |
For unit failure, replace WTS. | ||
Was this page helpful?


