Engine Mechanical System
Muffler Repair procedures
In this manual: Engine Mechanical System
11steps
~66min
3/5difficulty
Done 0 of 11
Removal and Installation
Front Muffler
Disconnect the heated oxygen sensor connector (A) and then remove it from the bracket.

Remove the under cover (A).
Tightening torque : 7.8 - 9,8 N·m

Detach the rubber hanger (A) from the front muffler.
Remove the front muffler (B).
Tightening torque : 39.2 - 59 N·m

Install in the revere order of removal.
Center Muffler
Detach the rubber hanger (A) from center muffler.
Remove the center muffler (B).
Tightening torque : 39.2 - 59 N·m

Install in the reverse order of removal.
Rear Muffler
Detach the rubber hanger (A) from rear muffler.
Remove the rear muffler (B).
Tightening torque : 39.2 - 59 N·m

Install in the reverse order of removal.
Was this page helpful?