Body Electrical System
Overhead Console Lamp Repair procedures
In this manual: Body Electrical System
5steps
~30min
2/5difficulty
Done 0 of 5
Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.


Removal
Disconnect the negative (-) battery terminal.
Remove the two mounting screws.
And then remove the overhead console (A).

Remove the overhead console after disconnecting the connectors (A).

Installation
Install the overhead console lamp after connecting the connector.
Install the lens after tightening 2 screws.
Was this page helpful?