Body Electrical System

Rear Combination Lamp Repair procedures

25steps
~150min
4/5difficulty
Done 0 of 25

Removal

Rear Combination Lamp (Outside)

  1. Disconnect the negative (-) battery terminal.

  2. Using a screwdriver or remover, remove the rear combination lamp cover (A).

  3. Remove the rear combination lamp (A) after loosening the screws.

  4. Remove the rear combination lamp packing (A).

  5. Disconnect the rear combination lamp connector (A).

Rear Combination Lamp (Inside)

  1. Disconnect the negative (-) battery terminal.

  2. Using a screwdriver or remover, remove the rear combination lamp cover (A).

  3. Disconnect the connector (B) and then remove the rear combination lamp (A) after loosening the nuts.

Back up lamp

  1. Disconnect the negative (-) battery terminal.

  2. Remove the rear bumper cover.

    (Refer to Body - "Rear bumper Cover")

  3. Disconnect the back up lamp connector (A).

  4. Remove the back up lamp (A) after loosening the screws.

Bulb Replacement

Back Up Lamp

  1. Disconnect the negative (-) battery terminal.

  2. Remove the back up lamp bulb (B) by turning the socket (A) counterclockwise.

Installation

Rear Combination Lamp (Outside)

  1. Connect the rear combination lamp connector.

  2. Install the rear combination lamp.

  3. Install the rear combination lamp cover.

  4. Connect the negative (-) battery terminal.

Rear Combination Lamp (Inside)

  1. Install the rear combination lamp.

  2. Connect the rear combination lamp connector.

  3. Install the rear combination lamp cover.

  4. Connect the negative (-) battery terminal.

Back Up Lamp

  1. Install the back up lamp.

  2. Install the rear bumper cover.

  3. Connect the negative (-) battery terminal.