Body Electrical System

Rheostat Repair procedures

10steps
~60min
3/5difficulty
Done 0 of 10

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the crash pad lower panel.

    (Refer to Body - "Crash Pad Lower Panel")

  3. Remove the crash pad plate [LH] (A) after loosening the screws.

  4. Disconnect the crash pad side switch connector (A).

  5. Remove the crash pad side switch (A) after loosening the screws.

Installation

  1. Install the crash pad side switch.

  2. Connect the crash pad side switch connector.

  3. Install the crash pad plate [LH].

  4. Install the crash pad lower panel.

  5. Connect the negative (-) battery terminal.

Inspection

  1. Check for intensity of new rheostat switch. If the light intensity of the lamps changes smoothly without any flickering when the rheostat is turned, it can be assumed that the rheostat is normal.