LCD Modes

(1) SPORT Mode (if equipped)

This mode displays the Gauge, Lap Timer and G-Force.

(2) Trip Computer Mode

This mode displays driving information, such as the trip odometer, fuel consumption, and so on.

❈ For details, refer to "Trip Computer" in this chapter.

(3) Turn by Turn Mode (if equipped)

This mode displays the navigation status.

(4) LKA/SCC Mode (if equipped)

This mode displays the status of the Smart Cruise Control (SCC) and Lane Keeping Assist (LKA).

❈ For details, refer to "Smart Cruise Control (SCC)" and "Lane Keeping Assist (LKA)" in chapter 5.

(5) User Settings Mode

In this mode, you can change the settings for the doors, lamps, and so on.

(6) Main Warning Mode

This mode displays warning messages related to low tire pressure, malfunctions of the blind-spot collision warning and so on.

❈ To operate the LCD display modes, refer to "LCD Display Control" in this chapter.

SPORT Mode

This mode displays the Gauge, Lap Timer and G-Force.

Trip Computer Mode

This mode displays driving information, such as the trip odometer, fuel consumption, and so on.

❈ For details, refer to "Trip Computer" in this chapter.

Turn by Turn Mode

This mode displays the navigation status.

SCC with S&G/LKA Mode

This mode displays the status of the Smart Cruise Control with Stop & Go and Lane Keeping Assist (LKA).

❈ For details, refer to "Smart Cruise Control with Stop & Go" and "Lane Keeping Assist (LKA)" in chapter 5.

Service Mode

When Service Required is set, the remaining distance/time until service is required is displayed on the LCD screen.

When the remaining distance is 1,500 km (900 miles) or the remaining time is 3 days, a service required message automatically appears and remains on the LCD screen for several seconds each time the Engine Start/Stop button is pressed.

When Service Required is set, a pop-up warning message "Service Required" appears when the total accumulated distance/driving time reaches a specified point.

In the Service Required mode, press and hold the OK button for more than 1 second. The values will return to the initial settings.

❈ Refer to User Settings Mode in this chapter for more information on setting Service Required.

Refer to User Settings Mode in this chapter for more information on setting Service Required.

❈ Service Required Setting

If the battery cable is disconnected or the fuse is in the OFF position, the Service Required setting values (distance/driving time) may change. In this case, re-enter the required service settings.

Main Warning Mode

• This warning light informs the driver of the following situations:

- LED headlamp malfunction (if equipped)
- Smart Cruise Control with Stop & Go malfunction (if equipped)
- Forward Collision-Avoidance Assist malfunction (if equipped)
- Blind-Spot Collision Warning radar cover blocked (if equipped)
- Smart Cruise Control with Stop & Go radar cover blocked (if equipped)
- Bulb malfunction
- High Beam Assist malfunction (if equipped)
- Low windshield washer fluid level

The master warning light illuminates if one or more of the above warning conditions occur. At this time, the LCD mode icon changes from ( ) to ( ).

If the warning condition is resolved, the master warning light turns off, and the LCD mode icon changes back to the previous icon ( ).