Kia Cee'd Quiz
Dual Clutch Transmission (DCT) System

Clutch Actuator Motor 2 (Even Gear) Repair Procedures

In this manual: Dual Clutch Transmission (DCT) System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
10steps
~60min
3/5difficulty
010203040505.44N·mlb·ft
Tightening torque found on this page
Done 0 of 10

Inspection

  1. Turn the ignition off.
  2. Disconnect the clutch actuator motor connector (A).
  3. Measure the resistance at the clutch actuator motor terminals.
  4. Refer to the specifications and check that the measured resistance is as specified. (Refer to Clutch Actuator Motor 2 - Specifications)

Removal

  1. Turn the ignition switch OFF, then disconnect the battery negative (-) cable.
  2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner")
  3. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")
  4. Remove the ECM. (Refer to Fuel System - "Engine Control Module (ECM)").
  5. Disconnect the clutch actuator motor connector (A).
  6. Loosen the mounting screw, then remove the clutch actuator motor (A).

    Tightening torque: 4.4 - 5.4 N·m

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.