Kia Cee'd Quiz
Dual Clutch Transmission (DCT) System

Inhibitor Switch Repair Procedures

In this manual: Dual Clutch Transmission (DCT) System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
9steps
~59min
3/5difficulty
1special tools
0102030405014.711N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Inspection

  1. Inspect for loose connectors, faulty connections, bends, corrosion, contamination, deformation, or damage.
  2. Disconnect the inhibitor switch connector.
  3. Check the voltage at the power source terminal and the ground wiring of the inhibitor switch.

    Standard voltage: approximately 12 V

  4. Use the following signal code table to check the electrical current flow for each terminal in each gear.

Removal

  1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner")
  2. Disconnect the shift lock switch connector (A).
  3. Remove the shift cable mounting nut (A).

    Tightening torque: 9.8 ~ 14.7 N·m

  4. Loosen the nut (A) and remove the manual control lever (B).
  5. Loosen the mounting bolt and remove the inhibitor switch (C).

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.