Kia Cee'd Quiz
Body Electrical System

Relay Box (Engine Compartment) Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
12steps
~72min
3/5difficulty
Done 0 of 12

Inspection

Power Relay Inspection (Type A)Check the circuit between the terminals for continuity.
A: C/Fan Relay (Low)
B: C/Fan Relay (High)
C: Fan Relay
D: SSB2 (ACC) Relay		 E: Rear Window Heater Relay
F: SSB4 (IG2) Relay
G: SSB3 (IG1) Relay
H: Starter Relay

  1. There should be continuity between terminals No. 30 and No. 87 when power and ground are connected to terminals No. 85 and No. 86.
  2. There should be no continuity between terminals No. 30 and No. 87 when power is disconnected.
  3. There should be continuity between terminals No. 30 and No. 87 when power and ground are connected to terminals No. 85 and No. 86.
  4. There should be continuity between terminals No. 30 and No. 87 when power is disconnected.
  5. There should be continuity between terminals No. 30, 87A and No. 87 when battery voltage and ground are applied to terminals No. 85 and No. 86.
  6. There should be no continuity between terminals No. 30, 87A and No. 87 when power is removed.
  7. Disconnect the negative (-) battery terminal.
  8. Push the 3 hooks on the relay box in the engine compartment in the direction of the arrow, and install the EMS assembly (A).
  9. Disconnect the connector and remove the EMS assembly (A).
  10. Make sure the fuse holders have no play and that the fuses are held securely.
  11. Is the rating of the fuse specified correctly for each circuit?
  12. Is any fuse blown? If a fuse must be replaced, always use a new fuse of the same rating. Always determine why the fuse blew and fully correct the problem before installing a new fuse.
Power Relay Inspection (Type B) Check continuity between the terminals. A: ESS Relay B: Wiper Relay C: HAC Relay. Power Relay Inspection (Type C) Check continuity between the terminals. A: PTC (GSL) / Fuel Heater Relay (DSL) B: Glow Plug Relay C: PTC3 Relay D: PTC2 Relay E: PTC1 Relay. EMS Box Replacement. Fuse Inspection. Multi Fuse. The Multi Fuse is designed to optimize the engine compartment package.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.