Kia Cee'd Quiz
Engine Mechanical System

Water Temperature Control Assembly Repair Procedures

In this manual: Engine Mechanical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
8steps
~48min
3/5difficulty
0102030405011.79N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Removal and Installation

  1. Loosen the drain plug and drain the engine coolant. Remove the radiator cap to drain quickly.
  2. Disconnect the negative battery cable.
  3. Remove the air cleaner assembly. (Refer to Air Intake and Exhaust System - "Air Cleaner").
  4. Disconnect the water temperature sensor connector. (Refer to Fuel System - Engine Control System)
  5. Disconnect the radiator upper hose.
  6. Remove the heater hose.
  7. Remove the water temperature control unit (B) after disconnecting the water hose (A).

    Tightening torque: 9.8 ~ 11.7 N·m

  8. Install in the reverse order of removal.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.