Kia Picanto JA Quiz
Engine Mechanical System

Engine Mounting

In this manual: Engine Mechanical System
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
16steps
~96min
4/5difficulty
02040608010063.747N·mlb·ft
Tightening torque found on this page
Done 0 of 16

Components and Component Location

Components

1. Engine Mounting Bracket
2. Roller Rod Bracket		 3. Transaxle Mounting Bracket

Repair Procedures

Removal and Installation

Engine Mounting Bracket
  1. Remove the engine undercover and the right side cover. (Refer to Engine and Transaxle Assembly - Engine Room Under Cover)
  2. Remove the coolant reservoir. (Refer to Cooling System - "Reservoir")
  3. Place a jack against the edge of the upper oil pan to support the engine.
  4. Remove the engine mounting bracket (A).

    Tightening Torque: 49.0–64 N·m

  5. Install in the reverse order of removal.
  6. Remove the engine cover. (Refer to Engine and Transaxle Assembly - Engine Cover)
  7. Remove the intake hoses and intercooler pipe (A). Tightening torque: Hose clamp bolt: 4.9–6.9 N·m N·m (If equipped with a cap, tighten until the cap breaks off.) Pipe mounting bolt: 18.6–24 N·m N·m
  8. Remove the roller rod bracket (A). Tightening torque: Bolt (B): 127.5–147 N·m N·m Bolt (C): 49.0–64 N·m N·m
  9. Install in the reverse order of removal.
  10. Remove the battery and tray. (Refer to Engine Electrical System — "Battery")
  11. Remove the engine undercover and the left side cover. (Refer to Engine and Transaxle Assembly - Engine Room Under Cover)
  12. Install the jack to the edge of the transaxle.
  13. Remove the transaxle side panel seal (A).
  14. Remove the transmission mounting bolts (A).

    Tightening torque: 88.2 - 108 N·m

  15. Remove the transaxle mounting bracket (A).

    Tightening Torque: 49.0–64 N·m

  16. Install in the reverse order of removal.
Roller Rod Bracket, Transaxle Mounting Bracket

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.