Kia Picanto JA Quiz
Body (Interior and Exterior)

Rear Bumper Beam Assembly

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
6steps
~36min
2/5difficulty
Done 0 of 6

Components and Component Location

Component Location

1. Rear bumper beam assembly

Repair Procedures

Replacement

  1. Remove the rear bumper cover. (Refer to Rear Bumper - Rear Bumper Assembly)
  2. Disconnect the rear bumper beam mounting wiring harness (A).
  3. Remove the rear smart key antenna (A) after loosening the mounting screws.
  4. Disconnect the extension wiring mounting clip (A).
  5. Remove the rear bumper beam assembly (A) after loosening the mounting clips.
  6. Install in the reverse order of removal.

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.