Kia Picanto JA Quiz
Body (Interior and Exterior)

Rear Bumper Assembly

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
10steps
~60min
3/5difficulty
Done 0 of 10

Components and Component Location

Component Location

1. Rear bumper cover

Repair Procedures

Replacement

  1. Separate the rear combination lamp (A) after loosening the mounting screws.
  2. Disconnect the waterproof seal (A).
  3. Disconnect the rear combination lamp connector (A).
  4. Loosen the upper rear bumper fastener.
  5. Remove the side part of the rear bumper after loosening the mounting screws.
  6. Disconnect the rubber mounts (A) from the muffler (B).
  7. Remove the lower rear bumper mounting bolts. [Left]
    [RH]
  8. Disconnect the rear bumper wiring connector (A).
  9. Remove the rear bumper assembly (A).
  10. Install in the reverse order of removal.

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.