Sunroof

Components and Component Location

Components

Repair Procedures

Adjustment

1. 1
   Check the step height between the roof panel (A) and the glass seal (B), and adjust if necessary. Alignment Adjustment Standard value [mm (in)] (1) Front edge: 0 mm (0 in) (2) Rear edge: 0 mm (0 in) (3) Side edge: 0 mm (0 in)

   

2. 2
   Adjust the glass height by slightly loosening the screws (A).

   

3. 3
   After initial vehicle assembly.
4. 4
   If the original value is erased or damaged due to a short circuit during operation.
5. 5
   After using the manual handle.
6. 6
   Use the emergency sunroof handle to close or open the sunroof manually if the sunroof cannot be operated electrically due to a motor or controller electrical malfunction.

   

7. 7
   If necessary, initialize the sunroof according to the initialization procedure. Whenever the vehicle battery is disconnected or discharged, or the emergency handle is used to operate the sunroof, the sunroof system must be reset as follows:

   1. Turn the ignition switch to the ON position and fully close the sunroof.
   2. Release the sunroof control lever.
   3. Press and hold the CLOSE button for more than 10 seconds until the sunroof closes and moves slightly back.
   4. Release the sunroof control lever.
   5. Press and hold the CLOSE button again for less than 3 seconds until the sunroof operates in the following sequence: Tilt down → Slide open → Slide close. Then release the switch.
   6. The sunroof system reset procedure is complete.