Kia Picanto JA Quiz
Body (Interior and Exterior)

Rear Pillar Trim

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
11steps
~66min
3/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 11

Components and Component Location

Component Location

1. Rear Pillar Trim

Repair Procedures

Replacement

  1. Remove the rear seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  2. Remove the rear door trim using a remover.
  3. Remove the parcel shelf (A).
  4. Disconnect the rear door weatherstrip.
  5. Remove the rear cross garnish (A).
  6. Disconnect the lower anchor of the rear seat belt (A) after loosening the mounting bolt.

    Torque: 39.2 – 54 N·m

  7. Remove the folding bracket (A) after loosening the mounting bolts.
  8. Remove the luggage compartment side trim (A) after loosening the fixing screws.
  9. Disconnect the luggage compartment lamp connector (A).
  10. Remove the rear door pillar trim (A).
  11. Install in the reverse order of removal.

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.