Kia Rio YB Quiz
Manual Transmission

Control Cable

In this manual: Manual Transmission
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
19steps
~114min
4/5difficulty
0102030405014.711N·mlb·ft
Tightening torque found on this page
Done 0 of 19

Components and Component Location

Components

1. Knob
2. Boot
3. Shift Lever Assembly		 4. Retainer
5. Shift Cable
6. Select Cable

Repair Procedures

Removal

  1. Move the shift lever to 4th gear.

  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Remove the battery and battery tray.

    (Refer to Engine Electrical System - Battery)

  4. Remove the control cable.

    1. Remove the control cable from the control shaft after removing the stopper pins (A).

    2. Remove the control cable (B) from the bracket (C).

  5. Remove the floor console assembly.

    (Refer to Body - Floor Console Assembly)

  6. Remove the lock pin (A), then remove the select cable from the shift lever pin.

  7. Remove the shift cable (A).

    [Type]

    [Type B]

  8. Remove the cable connectors (A) from the shift lever.

  9. Remove the shift cable bracket (A) after loosening the nuts (B). Then remove the shift cable by pulling it toward the passenger compartment.

Installation

  1. Install the shift cable bracket (A) by tightening the nuts (B).

    Tightening torque: 11.8–14.7 N·m

  2. Install the cable sockets (A).

  3. Install the shift cable (A).

    [Type]

    [Type B]

  4. Install the select cable on the lever pin, then insert the lock pin (A).

  5. Make sure the shift lever and control shaft are in the 4th position, then install the 4th lock pin (A).

  6. Install the control cable.

    1. Pull the holder (A) in the "R" direction, then pull the lock (B) in the "F" direction.

    2. Install the lock pins (A) after installing the control cable (B).

    3. Press the lock (C) after installing the control cable onto the control shaft.

    4. Remove the 4th lock pin (A).

  7. Check that the control shaft lever operates correctly when pressed (1st, 2nd, 3rd, 4th, 5th, 6th, reverse).

  8. Install the battery and battery tray.

    (Refer to Engine Electrical System - Battery)

  9. Install the air cleaner assembly.

    (Refer to Engine Mechanical System - "Air Cleaner")

  10. Install the floor console assembly.

    (Refer to Body - Floor Console Assembly)

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.