Kia Rio YB Quiz
Engine Mechanical System

Engine Mounting

In this manual: Engine Mechanical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
18steps
~108min
4/5difficulty
04080120160200107.880N·mlb·ft
Tightening torque found on this page
Done 0 of 18

Components and Component Location

Components

1. Engine Mounting Bracket
2. Engine Support Bracket		 3. Roll Rod Bracket
4. Transaxle Mounting Bracket

Repair Procedures

Removal and Installation

Engine Mounting Bracket

  1. Remove the engine room cover.

    (See Engine and Transaxle Assembly - Under Hood)

  2. Place a jack against the edge of the upper oil pan to support the engine.

  3. Remove the engine mount support bracket (A).

    Tightening Torque

    Nut (B):

    88,2–108 N·m

    Bolt and nuts (C):

    58,8–74 N·m

  4. Remove the engine mounting bracket (A).

    Tightening Torque: 49.0–64 N·m

  5. Install in the reverse order of removal.

Roll Rod Bracket

  1. Remove the idler arm bracket (A).

    Tightening Torque

    Bolt (B):

    49,0–64 N·m

    Bolt (C):

    107,9–128 N·m

  2. Remove the roller rod bracket (A).

    Tightening Torque: 49.0–69 N·m

  3. Install in the reverse order of removal.

Transaxle Mount Bracket

  1. Remove the engine room cover.

    (See Engine and Transaxle Assembly - Under Hood)

  2. Remove the air duct.

    (See Intake and Exhaust System - Air Cleaner)

  3. Remove the air cleaner assembly.

    (See Intake and Exhaust System - Air Cleaner)

  4. Remove the engine control module (ECM).

    (Refer to Engine Control System / Fuel System - "Engine Control Module (ECM)").

  5. Remove the battery and battery tray.

    (Refer to Engine Electrical System - Battery)

  6. Install the jack to the edge of the transaxle.

  7. Remove the service cover (A).

  8. Remove the transaxle bracket mounting bolts (A).

    Tightening torque: 88.2 - 108 N·m

  9. Remove the transaxle mounting bracket (A).

    Tightening Torque: 49.0–64 N·m

  10. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.