For Frontal Collision
When SRS is activated in a collision
WORK PROCEDURE
Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
Replace the diagnosis sensor unit.
Remove the front air bag modules, knee air bag module, crash zone sensor assembly, bracket and seat belt pre-tensioner assemblies.
Check the SRS components using the table below.
Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc).
Install new front air bag modules, knee air bag module, crash zone sensor assembly, bracket and seat belt pre-tensioner assemblies.
Perform self-diagnosis using CONSULT or air bag warning lamp. Refer to System Description for details.
Ensure entire SRS operates properly.
After the work is completed, check that no malfunction is detected by air bag warning lamp.
SRS INSPECTION (FOR FRONTAL COLLISION)
| Part | Inspection |
|---|---|
| Driver air bag module | If the driver air bag has deployed: REPLACE Install with new fasteners. |
| Driver knee air bag module | If the driver knee air bag has deployed: REPLACE Install with new fasteners. |
| Front passenger air bag module | If the front passenger air bag has deployed: REPLACE Install with new fasteners. |
| Front passenger knee air bag module | If the front passenger knee air bag has deployed: REPLACE Install with new fasteners. |
| Crash zone sensor | If any of the front air bags or seat belt pre-tensioners* have been activated: REPLACE the crash zone sensor and bracket with new fasteners. *: Confirm seat belt pre-tensioner activation using CONSULT only. |
Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) |
If either the driver or passenger seat belt pre-tensioner* has been activated: REPLACE all seat belt pre-tensioner assemblies with new fasteners. *: Confirm seat belt pre-tensioner activation using CONSULT only. |
| Diagnosis sensor unit | If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners. |
| Steering wheel |
|
| Spiral cable | If the driver front air bag has deployed: REPLACE the spiral cable. |
| Occupant classification system (Passenger seat) |
|
| Harness and connectors |
|
| Instrument panel assembly | If the front passenger air bag and/or knee air bag has deployed: REPLACE the instrument panel assembly. (integrated type) |
When SRS is not activated in a collision
WORK PROCEDURE
Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
Check the SRS components using the table below.
Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc).
Perform self-diagnosis using CONSULT or air bag warning lamp. Refer to System Description for details.
Ensure entire SRS operates properly.
After the work is completed, check that no malfunction is detected by air bag warning lamp.
SRS INSPECTION (FOR FRONTAL COLLISION)
| Part | Inspection |
|---|---|
| Driver air bag module | If the driver air bag has not been activated:
|
| Driver knee air bag module | If the driver knee air bag has not been activated:
|
| Front passenger air bag module | If the front passenger air bag has not been activated:
|
| Front passenger knee air bag module | If the front passenger knee air bag has not been activated:
|
| Crash zone sensor | If the front air bags or seat belt pre-tensioners have not been activated:
|
Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) |
If the pre-tensioners have not been activated:
|
| Diagnosis sensor unit | If none of the SRS components have been activated:
|
| Steering wheel |
|
| Spiral cable | If the driver front air bag has not deployed:
|
| Occupant classification system (Passenger seat) |
|
| Harness and connectors |
|
| Instrument panel assembly | If the passenger front air bag has not deployed:
|