In this manual: Cruise Control & Driver Assistance
~6min read
Exploded View
SIDE RADAR FRONT
Front bumper fascia
Front LH side radar bracket
Side radar front LH
Side radar front RH
Front RH side radar bracket
SIDE RADAR REAR
Rear bumper fascia
Rear RH side radar bracket
Rear RH side radar
Rear RH side radar bracket cover
Rear LH side radar bracket cover
Rear LH side radar
Rear LH side radar bracket
Removal and Installation
FRONT SIDE RADAR
REMOVAL
Remove front bumper fascia. Refer to Removal and Installation.
Disconnect front side radar harness connector , follow the procedure below.
Slide the lock of the connector toward the direction (1). Keep pushing (2) in the lock of connector and remove the harness connector to ward the direction (3).
Release pawls , and remove the front side radar from front side radar bracket .
INSTALLATION
Degrease and clean the inner side of the front bumper fascia base line and then apply primer (3M K500,K520 or equivalent) on the front side radar bracket installing face , which is shown as on the figure.
Dry the primer for more than 3 minutes and peel off the double sided tape releasing paper (film).
Install the front side radar bracket to the front bumper fascia and pressure bond the front side radar bracket.
Shake the front side radar bracket up and down and then right and left to confirm that the front side radar bracket to front bumper fascia has been installed (bonded) firmly.
Install the front side radar by locking it with the pawls of the front side radar bracket .
Connect front side radar harness connector , follow the procedure below.
Install harness connector to ward the direction (1). Push the lock of the connector toward the direction (2).
Install the front bumper fascia. Refer to Removal and Installation.
SIDE RADAR REAR
REMOVAL
Remove rear bumper fascia. Refer to Removal and Installation.
Release clips , and remove the rear side radar bracket cover .
Disconnect rear side radar harness connector , follow the procedure below.
Slide the lock of the connector toward the direction (1). Keep pushing (2) in the lock of connector and remove the harness connector to ward the direction (3).
Release pawls , and remove the rear side radar from rear side radar bracket .
INSTALLATION
Degrease and clean the inner side of the rear bumper fascia base line and then apply primer (3M K500,K520 or equivalent) on the rear side radar bracket installing face , which is shown as on the figure.
Dry the primer for more than 3 minutes and peel off the double sided tape releasing paper (film).
Install the rear side radar bracket to the rear bumper fascia and pressure bond the rear side radar bracket.
Shake the rear side radar bracket up and down and then right and left to confirm that the rear side radar bracket to rear bumper fascia has been installed (bonded) firmly.
Install the rear side radar by locking it with the pawls of the rear side radar bracket .
Connect rear side radar harness connector , follow the procedure below.
Install harness connector to ward the direction (1). Push the lock of the connector toward the direction (2).
Install the rear side radar bracket cover to rear side radar bracket.
Install the rear bumper fascia. Refer to Removal and Installation.