Side Radar Alignment
Work Procedure
Always perform the side radar alignment after performing the following work.
After removing and installing or replacing the side radar.
After removing and installing, replacing or repainting the rear bumper.
Side radar alignment conditions are following;
The vehicle speed is 20 km/h or higher.
The objects which reflect the wave of radar is located 2 m or more away from the vehicle.
The steering wheel is straight.
SELECT WORK SUPPORT ITEM
Stop the vehicle.
Select “Work support” of “Side radar (Front left)”, “Side radar (Front right)”, “Side radar (Rear left)” or “Side radar (Rear right)”.
Select “Side radar alignment”.
Is the screen to select the target side radar displayed?
YES>>GO TO 2.
NO>>When error message is displayed: GO TO 4.
START SIDE RADAR ALIGNMENT
Select “Start”.
Is “Ready to start the side radar alignment.” displayed?
YES>>GO TO 3.
NO-1>>When “Abnormal side radar installation.” is displayed: GO TO 5.
NO-2>>When “Detecting DTC.” is displayed: GO TO 6.
NO-3>>When “Stopped” is displayed: Perform side radar alignment again.
PERFORM SIDE RADAR ALIGNMENT
Drive the vehicle.
Confirm that “Side radars alignment are completed.” is displayed and select "End".
| Set vehicle speed indicator | Description |
|---|---|
| 0 – 99 | Display the progress of side radar adjustment |
| 112 (blink) | Progress rate of any one side radar is 100% (not an indication that the side radar adjustment is complete). |
| 128 | When an error occurs during side radar |
| 144 | When the radar irradiation angle of the side radar is abnormal |
The side radar adjustment progress rate is displayed as the progress rate of the side radar with the slowest progress.
When the side radar adjustment is complete, 100 blink for a moment and then 112 Lighting.
>>WORK END.
CONFIRMATION OF UNDETECTED RADAR
Confirm undetected radar and repair the defective part.
Perform the side radar alignment again.
WORK END.
CHECK THE CONNECTORS OF SIDE RADAR LH/RH
Confirm the description on CONSULT, check the concerned radar installing condition (installed location, tightening torque, bend of bracket etc.) and repair the defective part.
Perform the side radar alignment again.
WORK END.
CHECK SELF-DIAGNOSIS RESULTS OF SIDE RADAR
Perform "All DTC Reading".
Check if the DTC is detected on the self-diagnosis results of following.
Side radar (Front left): Refer to DTC Index.
Side radar (Front right): Refer to DTC Index.
Side radar (Rear left): Refer to DTC Index.
Side radar (Rear right): Refer to DTC Index.
Perform trouble diagnosis for the detected DTC, and repair or replace the identified malfunctioning parts.
Ignition switch OFF to ON, and perform the side radar alignment again.
WORK END.