Engine knock
Description
CHART 16: ENGINE KNOCK
Diagnosis Procedure
1.CHECK ENGINE OILCheck the grade of engine oil. Refer to LU-33, "Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace engine oil. Refer to LU-34, "Refilling".
2.CHECK ENGINE OIL LEVELIs the engine oil level correct? Yes or No Yes >> GO TO 3.
No >> Top up the oil.
3.CHECK ECM POWER SUPPLY AND GROUND CIRCUITCheck ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace harness or connector.
4.CHECK WIRING HARNESSVisually check the condition of the engine wiring harness.
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace harness or connector.
5.CHECK AIR INTAKE SYSTEMCheck air intake system. Refer to EM-280, "Removal and Installation".
Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace air intake system.
6.CHECK ELECTRIC THROTTLE CONTROL ACTUATORCheck electric throttle control actuator. Refer to EC-909, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 7.
NO >> Repair or replace.
7.CHECK MASS AIR FLOW SENSORCheck mass air flow sensor. Refer to EC-902, "Component Inspection".
Is the inspection result normal? YES >> GO TO 8.
NO >> Repair or replace.
8.CHECK CATALYTIC CONVERTERIs the catalytic converter clogged or deteriorated? Is the inspection result normal? YES >> GO TO 9.
NO >> Repair or replace.
9.CHECK HIGH PRESSURE SUPPLY PUMP (PRESSURE CONTROL VALVE)Perform the TEST 3: HIGH PRESSURE SUPPLY PUMP (PRESSURE CONTROL VALVE). Refer to EC-868, "Work Procedure [TEST 3: High Pressure Supply Pump (Pressure Control Valve) Check]".
>> GO TO 10.
10.CHECK HIGH PRESSURE SUPPLY PUMP (VOLUMETRIC CONTROL VALVE)Perform the TEST 4: HIGH PRESSURE SUPPLY PUMP (VOLUMETRIC CONTROL VALVE). Refer to EC- 869, "Work Procedure [TEST 4: High Pressure Supply Pump (Volumetric Control Valve) Check]".
>> GO TO 11.
11.CHECK RAIL HIGH PRESSURE CONTROL CIRCUITPerform the TEST 5: RAIL HIGH PRESSURE CONTROL CIRCUIT CHECK. Refer to EC-871, "Work Procedure (TEST 5: Rail High Pressure Regulation Check)".
>> GO TO 12.
12.CHECK MAJOR LEAK IN FUEL INJECTOR/FUEL INJECTORS OPENPerform the TEST 6: MAJOR LEAK IN FUEL INJECTOR/FUEL INJECTORS OPEN. Refer to EC-876, "Work Procedure (TEST 6: Fuel Injectors Leak Check)".
>> GO TO 13.
13.CHECK INCORRECT FUEL INJECTION QUANTITYPerform the TEST 7: INCORRECT FUEL INJECTION QUANTITY. Refer to EC-877, "Work Procedure (TEST 7: Fuel Injection Quantity Check)".
>> INSPECTION END