Starting difficult with cold engine
Description
CHART 3: STARTING DIFFICULT WITH COLD ENGINE
Diagnosis Procedure
1.CHECK ENGINE OIL LEVELIs the engine oil level correct? Yes or No Yes >> GO TO 2.
No >> Top up the oil.
2.CHECK ENGINE OILCheck the grade of engine oil. Refer to LU-33, "Inspection".
Is the inspection result normal? YES >> GO TO 3.
NO >> Replace engine oil. Refer to LU-34, "Draining", LU-34, "Refilling".
3.CHECK BATTERYCheck the battery. Refer to PG-113, "Work Flow".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace battery. Refer to PG-124, "Removal and Installation".
4.CHECK STARTER MOTORCheck the starter motor. Refer to STR-8, "STARTING SYSTEM (WITH INTELLIGENT KEY) : System Description" (With intelligent key), STR-9, "STARTING SYSTEM (WITHOUT INTELLIGENT KEY) : System Description" (With intelligent key).
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace starter motor.
5.CHECK COMPONENT PARTCheck the following.
• Engine coolant temperature sensor. Refer to EC-908, "Component Inspection". • Fuel temperature sensor. Refer to EC-916, "Component Inspection".• Intake air temperature sensor. Refer to EC-906, "Component Inspection".
Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace.
6.CHECK GLOW SYSTEMCheck the glow system. Refer to EC-936, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 7.
NO >> Repair or replace glow system. Refer to EM-292, "Removal and Installation".
7.CHECK LOW PRESSURE CIRCUITPerform the TEST 1: LOW PRESSURE CIRCUIT CHECK. Refer to EC-867, "Work Procedure (TEST 1: Low Pressure Fuel Supply System Check)".
>> GO TO 8.
8.CHECK INTERNAL FUEL TRANSFER PUMPPerform the TEST 2: INTERNAL FUEL TRANSFER PUMP CHECK. Refer to EC-868, "Work Procedure (TEST 2: Internal Fuel Transfer Pump Check)".
>> GO TO 9.
9.CHECK COMPRESSION PRESSURECheck the compression pressure.
>> INSPECTION END