Not communication with the ECM
Description
CHART 1: NO COMMUNICATION WITH THE ECM
Diagnosis Procedure
1.INSPECTION STARTEnsure that CONSULT-III is not causing the malfunction by trying to establish dialogue with an ECM on another vehicle. If the CONSULT-III is not at malfunction, and dialogue cannot be established with any other ECM on the same vehicle, the cause could be a suspected ECM interfering on the CAN communication line.
Check the voltage of the battery and carry out the operations necessary to obtain a voltage which is to specification (9.5 V < U battery < 17.5 V).
>> GO TO 2.
2.CHECK CAN COMMUNICATIONPerform trouble diagnosis on the CAN communication line using CONSULT-III. Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness or connector.
3.CHECK ECM GROUNDCheck the ECM earth (ground).
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace ground connection.
4.CHECK ECM POWER SUPPLY AND GROUND CIRCUITCheck ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace harness or connector.
5.CHECK DATA LINK CONNECTOR CIRCUITCheck for the presence of 12 V on terminal 16 with ignition switch OFF, 12 V on terminal 8 with ignition switch ON and an earth (ground) on terminals 4 and 5 of the data link connector.
Repair if necessary.
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair or replace harness or connector.