P0746 pressure control solenoid A
DTC Logic
DTC DETECTION LOGIC

NOTE
:
DC stands for "DRIVING CYCLE" and indicates a series of driving cycle of "Ignition switch OFF → ON → driving → OFF".
DTC CONFIRMATION PROCEDURE
CAUTION:Be careful of the driving speed. 1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION 1. Start the engine. 2. Drive the vehicle.3. Maintain the following conditions for 10 seconds or more.
Selector lever : “D” position Accelerator pedal position : 0.1/8 or more Vehicle speed : 40 km/h or more
4. Stop the vehicle.5. Check the first trip DTC.
Is “P0746”detected? YES >> Go to TM-423, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK LINE PRESSURE SOLENOID VALVE 1. Turn ignition switch OFF. 2. Disconnect the CVT unit connector.3. Check the line pressure solenoid valve. Refer to TM-423, "Component Inspection (Line Pressure Solenoid Valve)" Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK LINE PRESSUREPerform the line pressure test. Refer to TM-382, "Work Procedure".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Repair or replace the malfunction items.
Component Inspection (Line Pressure Solenoid Valve)
1.CHECK LINE PRESSURE SOLENOID VALVECheck the resistance between the CVT unit connector terminal and ground.

Is the inspection result normal? YES >> INSPECTION END
NO >> There is a malfunction of the line pressure solenoid valve. Replace the transaxle assembly. Refer to TM-508, "Removal and Installation".