Transaxle & transmissioN CVT: RE0F11A
P0846 transmission fluid pressure SEN/SW B
In this manual: Transaxle & transmissioN CVT: RE0F11A
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORKIf another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION 1. Start the engine. 2. Shift the selector lever to “D” position.3. Drive the vehicle at a constant velocity of 40 km/h at lease for 10 seconds.
CAUTION:At the same time, the accelerator pedal angle must be maintained constant. 4. Stop the vehicle.
5. Check the first trip DTC.
Is “P0846”detected? YES >> Go to TM-425, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK TCM INPUT SIGNAL 1. Start the engine.2. Check the voltage between TCM connector terminal and ground.

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> There is a malfunction of the secondary pressure sensor value. Replace the transaxle assembly.
Refer to TM-508, "Removal and Installation".
Was this page helpful?