Transaxle & transmission CVT: RE0F10B
Transmission range switch
In this manual: Transaxle & transmission CVT: RE0F10B
~1min read
Exploded View

1. Transmission range switch 2. Transaxle assem
Removal and Installation
REMOVAL
1. Remove battery. Refer to PG-124, "Removal and Installation". 2. Remove transmission range switch connector. 3. Remove control cable. Refer to TM-273, "Removal and Installation".4. Remove transmission range switch from transaxle assembly.
INSTALLATION
Install in the reverse order of removal.
Inspection and Adjustment
ADJUSTMENT OF TRANSMISSION RANGE SWITCH
1. Move selector lever to “N” position. 2. Remove control cable from manual lever. 3. Loosen mounting bolts (A) of transmission range switch. Insert a pin (φ4 mm) into the adjusting holes (B) on both transmission range switch and manual lever for adjusting the position. 4. Tighten mounting bolts of transmission range switch.5. Connect control cable on manual lever. Refer to TM-194, "Inspection and Adjustment".

ADJUSTMENT AFTER INSTALLATION
Adjust the CVT positions after installing the CVT shift selector. Refer to TM-194, "Inspection and Adjustment".
INSPECTION AFTER INSTALLAION
Check the CVT positions after adjusting the CVT positions. Refer to TM-194, "Inspection and Adjustment".
Was this page helpful?