Transaxle & transmission CVT: RE0F10B
Water hose
In this manual: Transaxle & transmission CVT: RE0F10B
~1min read
Exploded View

1. Hose clamp
2. Water hose
A. Water outlet
B. Oil warm
Removal and Installation
REMOVAL
WARNING:Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator. CAUTION:
Perform these steps after the coolant temperature has cooled sufficiently.
1. Remove the hose clamp and remove the water hose.
INSTALLATION
Note the following, and Install in the reverse order of removal.
CAUTION:Never reuse copper washer.
• Refer to the following when installing water hoses.

- Insert water hose according to dimension “L” described below.


- Set hose clamps (1) at the both ends of water hoses (2) with dimension “A” from the hose edge.
Dimension “A” : 5 – 7 mm (0.20 – 0.28 in)
- Hose clamp should not interfere with the bulge of fluid cooler tube.

Inspection
INSPECTION AFTER INSTALLATION
Start the engine, and check the joints for coolant leakage. Refer to CO-11, "Inspection".
Was this page helpful?