Transmission & Driveline

C1203 Abs System

2steps
~12min
1/5difficulty
Done 0 of 2
DTC Description

DTC DETECTION LOGIC

Malfunction related to wheel sensor has been detected by ABS actuator and electric unit (control unit).

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detecting condition
C1203

ABS SYSTEM

(ABS system)
Diagnosis condition Engine running and Nissan Murano vehicle running
Signal Nissan Murano Vehicle speed signal
Threshold —
Diagnosis delay time —

POSSIBLE CAUSE

ABS malfunction

  • Vehicle speed signal error

FAIL-SAFE

Front-wheel drive or shifts to 4-wheel drive (rear-wheels still have some driving torque).

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Start the engine and drive at 30 km/h or more for approximately 1 minute.

  2. Select “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”.

Is DTC “C1203” detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

SELECT ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF DIAGNOSTIC RESULT

CONSULT

Select “Self Diagnostic Result” mode of “ABS”.

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 2.

CHECK TERMINALS AND HARNESS CONNECTORS

Check AWD control unit pin terminals for damage or loose connection with harness connector.

Is inspection result normal?

YES>>

After ignition switch OFF, perform DTC confirmation procedure again. If DTC “C1203” is detected, replace AWD control unit. Refer to Removal and Installation.

NO>>

Repair or replace error-detected parts.