Transmission & Driveline

C1205 4wd Actuator Relay

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

Malfunction has been detected from AWD actuator relay integrated with AWD control unit, or malfunction related to AWD solenoid has been detected.

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detecting condition
C1205

4WD ACTUATOR RLY

(4WD actuator relay)
Diagnosis condition Ignition switch: ON
Signal —
Threshold —
Diagnosis delay time —

POSSIBLE CAUSE

  • Internal malfunction of AWD control unit

  • Malfunction of AWD solenoid power supply circuit (ground short)

FAIL-SAFE

Front-wheel drive or shifts to 4-wheel drive (rear-wheels still have some driving torque).

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”.

Is DTC “C1205” detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK AWD SOLENOID CIRCUIT (1)

  1. Ignition switch OFF.

  2. Disconnect AWD control unit harness connector.

  3. Check the continuity between AWD control unit harness connector and the ground.

    AWD control unit—Continuity
    ConnectorTerminal
    B135 1 Ground No
    2

Is the inspection result normal?

YES >>

GO TO 4.

NO>>

GO TO 2.

CHECK AWD SOLENOID

  1. Disconnect AWD solenoid harness connector.

  2. Check the continuity between AWD solenoid harness connector and the ground.

    AWD solenoid—Continuity
    ConnectorTerminal
    C12 1 Ground No
    2

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

AWD solenoid is malfunctioning. Replace electric controlled coupling. Refer to Removal and Installation.

CHECK AWD SOLENOID CIRCUIT

Check the continuity between AWD control unit harness connector and the ground.

AWD control unit—Continuity
ConnectorTerminal
B135 1 Ground No
2

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace damaged parts.

CHECK TERMINALS AND HARNESS CONNECTORS

  1. Check AWD control unit pin terminals for damage or loose connection with harness connector.

  2. Check AWD solenoid pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES>>

After connecting each harness connector, perform DTC confirmation procedure again. When DTC “C1205” is detected, replace AWD control unit. Refer to Removal and Installation.

NO>>

Repair or replace damaged parts.