Transmission & Driveline

U1000 Can Comm Circuit

2steps
~12min
1/5difficulty
Done 0 of 2
DTC Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a Nissan Murano vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit communicate data but selectively reads required data only.

DTC DETECTION LOGIC

AWD control unit is not transmitting/receiving CAN communication signal for 2 seconds or more.

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detecting condition
U1000

CAN COMM CIRCUIT

(CAN communication circuit)
Diagnosis condition Ignition switch: ON
Signal CAN communication signal
Threshold —
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

  • CAN communication error

  • Internal malfunction of AWD control unit

FAIL-SAFE

Front-wheel drive or shifts to 4-wheel drive (rear-wheels still have some driving torque).

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”.

Is DTC “U1000” detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

Proceed to Trouble Diagnosis Flow Chart.