Cruise Control & Driver Assistance

C1b50-49 Side Radar Malfunction

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1B50-49

SIDE RDR MALFUNCTION

(Side radar malfunction)
Diagnosis condition When ignition switch is ON.
Signal (terminal) –
Threshold Side radar malfunction
Diagnosis delay time –

POSSIBLE CAUSE

Side radar RH

FAIL-SAFE

The following systems are canceled:

  • Blind Spot Warning (BSW)

  • Rear Cross Traffic Alert (RCTA)

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Select “All DTC Reading” mode.

  3. Check if “C1B50-49” is detected as the current malfunction in “Self Diagnostic Result” mode of “Side radar (Rear right)”.

Is the “C1B50-49” detected as the current malfunction?

YES>>

Refer to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Turn ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “Side radar (Rear right)”.

  3. Select “ERASE”.

  4. Turn ignition switch OFF.

  5. Turn ignition switch ON.

  6. Check if any DTC other than “C1B50-49” is detected in “Self Diagnostic Result” mode of “Side radar (Rear right)”.

Is any DTC detected?

YES>>

Perform diagnosis on the detected DTC and repair or replace the malfunctioning part. Refer to DTC Index.

NO>>

Replace side radar RH. Refer to Removal and Installation.