Cruise Control & Driver Assistance

C1b51-16 Blind Spot Warning Indicator Short Circuit

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1B51-16

BSW/BSI IND SHORT CIR

(Blind Spot Warning indicator short circuit)
Diagnosis condition When ignition switch is ON.
Signal (terminal) –
Threshold Short circuit in Blind Spot Warning indicator circuit is detected. (Over current is detected)
Diagnosis delay time –

POSSIBLE CAUSE

  • Blind Spot Warning indicator RH circuit

  • Blind Spot Warning indicator RH

  • Side radar RH

FAIL-SAFE

The following systems are canceled:

  • Blind Spot Warning (BSW)

  • Rear Cross Traffic Alert (RCTA)

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Select “All DTC Reading” mode.

  3. Check if “C1B51-16” is detected as the current malfunction in “Self Diagnostic Result” mode of “Side radar (Rear right)”.

Is the “C1B51-16” detected as the current malfunction?

YES>>

Refer to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK BSW INDICATOR CIRCUIT FOR SHORT

  1. Turn ignition switch OFF.

  2. Disconnect side radar RH harness connector and BSW indicator RH harness connector.

  3. Check continuity between side radar RH harness connector and ground.

Side radar RH

Ground

Continuity
Connector Terminal
B466 4 No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the harnesses or connectors.

REPLACE THE BLIND SPOT WARNING INDICATOR

CONSULT

  1. Replace the blind spot warning indicator RH.

  2. Perform “All DTC Reading”.

  3. Check if the “C1B51-16” is detected in “Self Diagnostic Result” of “Side radar (Rear right)”

Is the DTC “C1B51-16” detected?

YES>>

Replace the side radar RH. Refer to Removal and Installation.

NO>>

Inspection End.