Cruise Control & Driver Assistance

U0104-82 Adas Can 1

8steps
~48min
2/5difficulty
Done 0 of 8
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U0104-82

ADAS CAN CIR1

(ADAS control unit CAN circuit 1)
Diagnosis condition When ignition switch is ON.
Signal (terminal) –
Threshold Side radar detected an error of ITS communication signal that was received from ADAS control unit
Diagnosis delay time –

POSSIBLE CAUSE

  • ADAS control unit

  • Side radar RH

FAIL-SAFE

The following systems are canceled:

  • Blind Spot Warning (BSW)

  • Rear Cross Traffic Alert (RCTA)

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Description.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Turn the Blind Spot Warning system ON.

  3. Select “All DTC Reading” mode.

  4. Check if “U0104-82” is detected as the current malfunction in “Self Diagnostic Result” mode of “Side radar (Rear right)”.

Is DTC “U0104-82” detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Description.

NO>>

GO TO 2.

SELF DIAGNOSTIC RESULT OF ADAS CONTROL UNIT

CONSULT

  1. Start the engine.

  2. Turn the Blind Spot Warning system ON.

  3. Select “Self Diagnostic Result” mode of “ICC/ADAS”.

  4. Check DTC.

Is DTC detected?

YES>>

Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.

NO>>

Replace side radar RH. Refer to Removal and Installation.