Cruise Control & Driver Assistance

C1b52-17 Blind Spot Warning Indicator Open Circuit

8steps
~48min
2/5difficulty
Done 0 of 8
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1B52-17

BSW/BSI IND OPEN CIR

(Blind Spot Warning indicator open circuit)
Diagnosis condition When ignition switch is ON.
Signal (terminal) –
Threshold Open circuit in Blind Spot Warning indicator circuit is detected
Diagnosis delay time –

POSSIBLE CAUSE

  • Blind Spot Warning indicator RH circuit

  • Blind Spot Warning indicator RH

  • Side radar RH

FAIL-SAFE

The following systems are canceled:

  • Blind Spot Warning (BSW)

  • Rear Cross Traffic Alert (RCTA)

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Select “All DTC Reading” mode.

  3. Check if “C1B52-17” is detected as the current malfunction in “Self Diagnostic Result” mode of “Side radar (Rear right)”.

Is the “C1B52-17” detected as the current malfunction?

YES>>

Refer to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK BLIND SPOT WARNING INDICATOR CIRCUIT FOR OPEN (1)

  1. Turn ignition switch OFF.

  2. Disconnect side radar RH harness connector and Blind Spot Warning indicator RH harness connector.

  3. Check continuity between side radar RH harness connector and Blind Spot Warning indicator RH harness connector.

Side radar RH Blind Spot Warning indicator RH Continuity
Connector Terminal Connector Terminal
B466 4 B111 1 Yes

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness or connector.

CHECK BLIND SPOT WARNING INDICATOR CIRCUIT FOR OPEN (2)

Check continuity between Blind Spot Warning indicator RH harness connector and ground.

Blind Spot Warning indicator RH Ground Continuity
Connector Terminal
B111 4 Yes

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connector.

CHECK SIDE RADAR VOLTAGE OUTPUT

  1. Connect side radar RH harness connector.

  2. Check voltage between Blind Spot Warning indicator RH harness connector and ground.

    Blind Spot Warning indicator RH Ground Condition

    Voltage

    (Approx.)
    Connector Terminal
    B111 1

    Ignition switch

    OFF ⇒ ON

    (Approx. 2 sec.)
    7 - 14 V

Is the inspection result normal?

YES>>

Replace Blind Spot Warning indicator RH. Refer to Removal and Installation.

NO>>

Replace side radar RH. Refer to Removal and Installation.