Ring Gear Shaft

| Oil seal | Transfer cover | Filler plug | |||
| Gasket | Drain plug | Oil seal | |||
| O-ring | Ring gear bearing adjusting shim (transfer cover side) | Ring gear bearing (transfer cover side) | |||
| Drive shaft oil seal | Ring gear shaft | Ring gear bearing (transfer case side) | |||
| Ring gear bearing adjusting shim (transfer case side) | Ring gear | Baffle plate | |||
| Transfer case | Plug | O-ring | |||
| Oil seal | Dowel pin | Drive pinion | |||
| Drive pinion adjusting shim | O-ring | Pinion bearing assembly | |||
| Oil seal | Dust cover | Companion flange | |||
| Pinion lock nut | |||||
| Oil seal lip | Comply with the assembly procedure when tightening. Refer to Disassembly and Assembly. | ||||
DISASSEMBLY
Remove transfer cover assembly. Refer to Disassembly and Assembly.
Remove ring gear bearing outer race (transfer cover side) and ring gear bearing adjusting shim (transfer cover side) from the transfer cover. Refer to Disassembly and Assembly.
Remove ring gear shaft assembly from the transfer case.
Remove ring gear bearing outer race (transfer case side) and ring gear bearing adjusting shim (transfer case side) from the transfer case. Refer to Disassembly and Assembly.
Remove ring gear bearing inner race (transfer cover side) from ring gear shaft with drift (A) (commercial service tool) and bearing separator (commercial service tool).

Remove ring gear bearing inner race (transfer case side) from ring gear shaft with Tool (A) and puller (commercial service tool).

| Tool number | : ST33061000 (J-8107–2) |
Remove the ring gear mounting bolts.
Lightly tap ring gear with a plastic hammer to remove ring gear from the ring gear shaft.

Remove drive shaft oil seal from the ring gear shaft using Tool (A).

| Tool number | : KV381054S0 (J-34286) |
Perform inspection after disassembly. Refer to Inspection.
ASSEMBLY
Using drift (A) (commercial service tool), install drive shaft oil seal
within the dimension (L) shown as follows.

| L | : 2.0 +0.6/−0 mm (0.079 +0.024/−0 in) |
Select ring gear bearing adjusting shim (transfer case side) and ring gear bearing adjusting shim (transfer cover side). Refer to Adjustment.
Assemble the selected ring gear bearing adjusting shim (transfer case side) and ring gear bearing outer race (transfer case side) to transfer case. Refer to Disassembly and Assembly.
Assemble the selected ring gear bearing adjusting shim (transfer cover side) and ring gear bearing outer race (transfer cover side) to transfer cover. Refer to Disassembly and Assembly.
Install the ring gear to ring gear shaft, and tighten mounting bolts to the specified torque.
Install ring gear bearing inner race (transfer cover side) with drift (A) (commercial service tool).

Install the ring gear bearing inner race (transfer case side) to ring gear shaft with drift (A) (commercial service tool).

Install the ring gear shaft assembly to the transfer case.
Apply multi-purpose grease to spline part indicated in the figure.

Install transfer cover to check and adjust each part. Refer to Disassembly and Assembly.
Check backlash, tooth contact, total preload and companion flange runout. Refer to Adjustment.
Reinstall transfer cover for installing O-ring. Refer to Disassembly and Assembly.
After installing transfer case oil seals, remove wrapped vinyl from the spline of ring gear shaft.
INSPECTION AFTER DISASSEMBLY
Check items below. If necessary, replace them with new ones.
Gear and Shaft
Check gear face and shaft for wear, cracks, damage, and seizure.
Bearing
Check for seizure, peeling, wear, corrosion, sticking, unusual noise, roughness in hand turning, and other damage.
Shim
Check for seizure, damage, and unusual wear.
Replace defective parts as necessary.