Transmission & Driveline

Transfer Cover

~3min read
Exploded View
Oil seal Transfer cover Filler plug
Gasket Drain plug Oil seal
O-ring Ring gear bearing adjusting shim (transfer cover side) Ring gear bearing (transfer cover side)
Drive shaft oil seal Ring gear shaft Ring gear bearing (transfer case side)
Ring gear bearing adjusting shim (transfer case side) Ring gear Baffle plate
Transfer case Plug O-ring
Oil seal Dowel pin Drive pinion
Drive pinion adjusting shim O-ring Pinion bearing assembly
Oil seal Dust cover Companion flange
Pinion lock nut
Oil seal lip Comply with the assembly procedure when tightening. Refer to Disassembly and Assembly.
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
: Apply gear oil.
*: Apply anti-corrosive oil.
: Apply multi-purpose grease.
: Select with proper thickness.
Disassembly and Assembly

DISASSEMBLY

Remove transfer cover mounting bolts ().

Lightly tap transfer cover with a plastic hammer to remove transfer cover.

Remove O-ring from transfer cover.

Lightly tap the metal part of oil seals with punch from back side of transfer cover to remove oil seals.

Remove the ring gear bearing adjusting shim (transfer cover side) and ring gear bearing outer race (transfer cover side) using drift (commercial service tool).

Remove drain plug and gasket.

Remove filler plug and gasket.

Perform inspection after disassembly. Refer to Inspection.

ASSEMBLY

Select the ring gear bearing adjusting shim (transfer cover side). Refer to Adjustment.

Install the selected ring gear bearing adjusting shim (transfer cover side) and ring gear bearing outer race (transfer cover side) using drift (commercial service tool).

Install gasket onto drain plug and install them to transfer cover.

Install the transfer cover to the transfer case, and apply anti-corrosive oil onto thread and seats on the mounting bolts. Then tighten mounting bolts to the specified torque.

A : M10 bolt
B : M8 bolt

Check backlash, tooth contact, total preload and companion flange runout. Refer to Adjustment.

Remove transfer cover to install O-ring.

Apply multi-purpose grease lightly and evenly onto an O-ring, and install it to the transfer cover.

Install the transfer cover to the transfer case, and apply anti-corrosive oil onto thread and seats on the mounting bolts. Then tighten mounting bolts to the specified torque.

A : M10 bolt
B : M8 bolt

Using drift (commercial service tool), drive the transfer cover oil seals.

A : 10.3 +0.6/-0 mm (0.406 +0.024/-0 in)
B : 0 +0.6/-0 mm (0 +0.024/-0 in)

Install gasket onto filler plug and install them to transfer cover.

Inspection

INSPECTION AFTER DISASSEMBLY

Check items below. If necessary, replace them with new ones.

transfer cover

Check the bearing mounting surface for wear, cracks and damages.

Check the bearing mounting surface for wear, cracks, and damages.

Replace mounting surface parts as necessary.