Transmission & Driveline

Transfer Case

~3min read
Exploded View
Oil seal Transfer cover Filler plug
Gasket Drain plug Oil seal
O-ring Ring gear bearing adjusting shim (transfer cover side) Ring gear bearing (transfer cover side)
Drive shaft oil seal Ring gear shaft Ring gear bearing (transfer case side)
Ring gear bearing adjusting shim (transfer case side) Ring gear Baffle plate
Transfer case Plug O-ring
Oil seal Dowel pin Drive pinion
Drive pinion adjusting shim O-ring Pinion bearing assembly
Oil seal Dust cover Companion flange
Pinion lock nut
Oil seal lip Comply with the assembly procedure when tightening. Refer to Disassembly and Assembly.
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
: Apply gear oil.
*: Apply anti-corrosive oil.
: Apply multi-purpose grease.
: Select with proper thickness.
Disassembly and Assembly

DISASSEMBLY

Remove transfer cover. Refer to Disassembly and Assembly.

Remove ring gear shaft assembly. Refer to Disassembly and Assembly.

Remove drive pinion assembly. Refer to Disassembly and Assembly.

Remove O-ring from transfer case.

Remove oil seals .

Remove baffle plate .

Remove the ring gear bearing adjusting shim (transfer case side) and ring gear bearing outer race (transfer case side) by tapping from the 2 cutouts () on the transfer case.

Remove plug and gasket.

Perform inspection after disassembly. Refer to Inspection.

ASSEMBLY

Select the ring gear bearing adjusting shim (transfer case side). Refer to Adjustment.

Install the selected ring gear bearing adjusting shim (transfer case side) and ring gear bearing outer race (transfer case side) using drift (A) (commercial service tool).

Install baffle plate .

Install ring gear shaft assembly. Refer to Disassembly and Assembly.

Install drive pinion assembly. Refer to Disassembly and Assembly.

Install transfer cover to check and adjust each part. Refer to =Disassembly and Assembly.

Check backlash, tooth contact, total preload and companion flange runout. Refer to Adjustment.

Reinstall transfer cover for installing O-ring. Refer to Disassembly and Assembly.

Install oil seals with drift (commercial service tool).

A : 24.8 mm (0.976 in)
B : 10.3 mm (0.406 in)

After installing oil seals to transfer case, remove wrapped vinyl from the spline of ring gear shaft.

Apply multi-purpose grease lightly and evenly onto an O-ring, and install it to the transfer case.

Inspection

INSPECTION AFTER DISASSEMBLY

Check items below. If necessary, replace them with new ones.

Case

Check the bearing mounting surface for wear, cracks and damages.

Replace defective parts as necessary.