Latching

Pull the webbing out slowly and smoothly, and make sure the latch plate 3 clicks into the buckle 5 (check that it is locked by pulling on latch plate 3).

If the belt locks, pull back firmly and then unroll it again.

If your belt is completely locked, pull the belt slowly but firmly to extract about 3 cm.

Let it retract on its own, then unroll it again.

If the problem persists, consult a brand representative.

Front seat belt not fastened
warning light

It lights up on the central display when the engine starts, then, if the driver or front passenger seat belt (when the seat is occupied) is not fastened and the vehicle reaches approximately 20 km/h, it flashes and an audible signal sounds for approximately 2 minutes.

Note: an object placed on the passenger seat may in some cases trigger the warning light.

Rear seat belt not fastened warning (depending on vehicle)

The warning lightIt lights up on
the central display, accompanied by a message on the instrument panel showing the number of fastened belts, for approximately 30 seconds each time:

• vehicle start-up;
• a door is opened;
• a rear seat belt is fastened or unfastened.

Make sure rear passengers are properly belted and that the number of belted seats shown matches the number of occupied seats on the rear bench.