Locking

Pull the belt webbing out slowly and smoothly, insert tongue 3 into buckle 5 and make sure they click together (check that the belt is locked by pulling on tongue 3).

If the belt webbing is locked, release the belt and pull it out again.

If the belt is fully locked, pull it firmly but slowly to release about 3 cm of webbing.

Release the belt to let the webbing retract onto the reel, then pull it out again.

If the problem persists, contact an authorised brand partner.

Warning lamp
for unfastened front seat belts

It lights on the central display when the engine starts. Then, if the driver's or front passenger's seat belt (when the seat is occupied) is not fastened and the vehicle reaches a speed of approximately 20 km/h, the light flashes and an audible signal sounds for about 2 minutes.

Note: an object placed on the passenger seat may in some cases cause the warning lamp to come on.

Rear seat belt unfastened warning (depending on vehicle version): the warning lamp lights on the central display, and the message display on the instrument panel shows the number of fastened belts for about 30 seconds, each time:

• the engine is started;
• a door is opened;
• a rear seat belt is fastened or unfastened.

Make sure rear passengers have their seat belts properly fastened and that the number of fastened belts shown matches the number of occupied rear seats.