Air recirculation control cable

LEFT-HAND DRIVE

REMOVAL

• Disconnect the battery, starting with the negative terminal.

• Pull out the heater control panel, tilting it towards the inside of the dashboard.

• Release the recirculation cable at (2).
• Spread the tab (3) apart.
• Pull out the ball joint (4).
• Remove the recirculation cable (1) fixed to the heater control panel.

Note: The recirculation control cable is black.

• Remove:

• the front sill trim (upper part) (Chapter Body interior trim),
• the side panel (5) of the dashboard.

• Unclip the passenger airbag disable switch.

• Remove:

• the fixing screws (6) of the glovebox,
• the glovebox.

• Press the clip (7).
• Remove the clip.
• Remove the ball joint of the cable fixed to the control lever (8).

INSTALLATION

• Refit in the reverse order of removal.

Connect the battery; carry out the necessary relearn procedures (Chapter Battery).

Note: The cable does not require adjustment.

• Torque the battery cover screws (0.4 daN.m).

RIGHT-HAND DRIVE

REMOVAL

• Disconnect the battery, starting with the negative terminal.

• Pull out the heater control panel, tilting it towards the inside of the dashboard.

• Release the recirculation cable at (2).
• Spread the tab (3) apart.
• Pull out the ball joint (4).
• Remove the recirculation cable (1) fixed to the heater control panel.

Note: The recirculation control cable is black.

• Remove:

• the front air distribution duct (Chapter Heating, Front air distribution duct, page 61A-4),
• the beam reinforcement plate cover.

• Disconnect the wiring harness attached to the body reinforcement plate.
• Remove:

• the four screws (6) securing the body reinforcement plate,
• the body reinforcement plate (5).

• Press the clip (7).
• Remove the clip.
• Disconnect the ball joint of the cable from the control lever (8).

INSTALLATION

• Refit in the reverse order of removal.

Connect the battery; carry out the necessary relearn procedures (Chapter Battery).

Note: The cable does not require adjustment.

• Tighten to the following torques:

• the body reinforcement plate mounting screws (2.1 daN.m),
• the battery cover bolts (0.4 daN.m).