Control module

The passenger compartment fan motor assembly control unit (electric control) is accessible from underneath the dashboard

REMOVAL

• Disconnect the battery, starting with the negative terminal.
• Remove:

• the relay bracket to access the passenger compartment fan motor assembly control unit (see Heating chapter, Heater resistor unit, page 61A-46) if the vehicle is fitted with a heater resistor unit,
• the front left air duct (see Heating chapter, Front air distribution duct, page 61A-4).

LEFT-HAND DRIVE

• Disconnect the connector (1) from the accelerator pedal.

RIGHT-HAND DRIVE

• Remove the brake pedal position switch (2) by turning it a quarter turn.

Example on a left-hand drive vehicle

• Disconnect the connector (3) from the passenger compartment fan motor assembly electronic unit.
• Remove the two mounting bolts (4) of the passenger compartment fan motor assembly electronic unit.
• Gently spread the mounting tabs of the electronic unit.

WARNING Handle the control unit mounting tabs with care.

• Remove the passenger compartment fan motor assembly control unit.

• Remove the connector (5) from the passenger compartment fan motor assembly.

INSTALLATION

RIGHT-HAND DRIVE

Be sure to position the moving part of the switch to minimum by pulling on the piston.

• Position the brake pedal position switch in its housing.
• Turn the brake pedal position switch a quarter turn clockwise.
• Reverse the removal procedure.

Connect the battery; carry out the necessary re-initialisation procedures (see Battery chapter).

• Torque the battery cover screws (0.4 daN.m).