Rear bumper beam

Tightening torques
nut (A)	2.1 daN.m
box bolt	3.5 daN.m

Replacing this part is a basic operation for a rear collision.

It is a bolted-on aluminium structural component.

In the operation described below, only the connections specific to the part concerned are described.

Information on related parts is covered in their respective sections (see contents).

REPLACEMENT PART CONTENTS

Assembly supplied with:
Front end crossmember
Side boxes
Bolts
Nuts

WARNING

The beam contributes to the rigidity of the structure in the event of an impact. Therefore, after any work on it, it is essential to observe the tightening torque.

REMOVAL

To access the bumper crossmember mountings, first remove:

• the rear lights,
• the rear mudguards,
• the rear bumper.

Remove the lateral mounting nuts (A) (three on each side).

Note: Depending on the severity of the impact, the beam can be replaced without removing the absorber boxes.

INSTALLATION

Refit in the reverse order of removal.

After any work requiring removal of the absorber boxes, check the condition of the beam foam and replace it if it is damaged.