BLUE LINK Module Repair Procedures

Removal

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the driver airbag module assembly. (Refer to Body - "Driver Airbag Module Assembly")
3. 3
   Remove the knee airbag (KAB) module. (Refer to Restraint System - Knee Airbag (KAB) Module.)
4. 4
   Remove the driver side shower duct. (Refer to Heating, Ventilation and Air Conditioning - Temperature Control Actuator.)
5. 5
   Disconnect the connector, loosen the nut and screws, then remove the blue connector block.

   

   

Installation

1. 1
   Install the blue connector block.
2. 2
   Install the main crash pad.
3. 3
   Connect the negative (-) battery terminal.

Inspection

Diagnosis with GDS

1. 1
   Body electrical system faults can be quickly diagnosed with the Global Diagnostic System (GDS). The GDS provides the following information.

   1. Self-Diagnosis: Diagnostic Trouble Code (DTC) check and display
   2. Current Data: Check the system input/output status.
   3. Actuator Test: Checking System Operating Status
   4. Additional Functions: Other controls such as system option and zero point adjustment.
2. 2
   Select "Vehicle Model" and the system to be checked to inspect the vehicle with the tester.
3. 3
   Select "Telematics Unit (TMU)" to inspect the telematics unit.
4. 4
   Select the "Current Data" menu to check the current status of input/output data. Input/output data for the sensors related to the TMU can be checked.

   

5. 5
   To check the TMU trouble code, select "Diagnostic Trouble Codes".