Swingarm bearing removal and installation

1. 1
   Remove the swingarm. Refer to “swingarm removal and installation” .
2. 2
   Remove the swingarm pivot bearings (1) using the special tool.

3. Remove the center spacer (2).

4. Remove the cushion lever bearing (3) using the special tool.

Caution the removed bearings must be replaced with new ones.

1. 1
   Install the center spacer.
2. 2
   Press the pivot bearings into the swingarm pivot to the depth “a” of 0 – 0.5 Mm (0 – 0.02 In) from the edge with the special tool and suitable size socket wrench.

when installing the bearing, stamped mark on the bearing must face outside and apply a small quantity of the grease to housing.

: Grease 99000–25010 (suzuki
super grease “a” or equivalent)

Special tool (a): 09941–34513 (bearing
installer)

0 – 0.5 Mm (0 – 0.02 In)

3. Press the cushion lever bearing into the swingarm to the depth “b” of 1.5 Mm (0.06 In) from the edge with the special tool and suitable size socket wrench.

apply a small quantity of the grease to housing when installing the bearing.

: Grease 99000–25010 (suzuki
super grease “a” or equivalent)

Special tool (b): 09924–84521 (bearing
installer set)

1.5 Mm (0.06 In)

4. Apply grease to the bearings.

: Grease 99000–25010 (suzuki
super grease “a” or equivalent)

5. Install the swingarm. Refer to “swingarm removal and installation” .