Toyota 4Runner: Data Signal Circuit between Navigation Receiver Assembly and Extension Module

DESCRIPTION

The stereo component tuner assembly sends the sound data signal or image data signal from a device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM
CAUTION / NOTICE / HINT

NOTICE:

After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

PROCEDURE

CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)

(a) Disconnect the s1 and t1 navigation receiver assembly connectors.

(b) Disconnect the s2 and t2 stereo component tuner assembly connectors.

Standard Resistance:

Tester Connection	Condition	Specified Condition
s1-1 (USV4) - s2-1 (USV4)	Always	Below 1 Ω
s1-2 (US4-) - s2-2 (US4-)	Always	Below 1 Ω
s1-3 (US4+) - s2-3 (US4+)	Always	Below 1 Ω
s1-4 (UGD4) - s2-4 (UGD4)	Always	Below 1 Ω
s1-5 (USG4) - s2-5 (USG4)	Always	Below 1 Ω
t1-4 (+B2) - t2-4 (+B2)	Always	Below 1 Ω
t1-3 (ACC2) - t2-3 (ACC2)	Always	Below 1 Ω
t1-8 (GND2) - t2-8 (GND2)	Always	Below 1 Ω
s1-1 (USV4) - Body ground	Always	10 kΩ or higher
s1-2 (US4-) - Body ground	Always	10 kΩ or higher
s1-3 (US4+) - Body ground	Always	10 kΩ or higher
s1-4 (UGD4) - Body ground	Always	10 kΩ or higher
s1-5 (USG4) - Body ground	Always	10 kΩ or higher
t1-4 (+B2) - Body ground	Always	10 kΩ or higher
t1-3 (ACC2) - Body ground	Always	10 kΩ or higher
t1-8 (GND2) - Body ground	Always	10 kΩ or higher

REPAIR OR REPLACE HARNESS AND CONNECTOR

REPLACE NO. 1 NAVIGATION WIRE

(a) Replace the No. 1 navigation wire (See page ).

(b) Check that the malfunction disappears.

OK:

Malfunction disappears.

END (NO. 1 NAVIGATION WIRE IS DEFECTIVE)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Data Signal Circuit between Navigation Receiver Assembly and Extension Module

Test yourself