Toyota 4Runner Quiz
Audio / Visual / Telematics

Navigation Receiver Assembly Power Source Circuit

In this manual: Audio / Visual / Telematics
General — 25Audio / Visual / Telematics — 283Brake — 187Drivetrain — 204Power Source / Network — 79Steering — 76Suspension — 130Vehicle Exterior — 391Vehicle Interior — 693
~1min read
DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM
CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY, BODY GROUND)

(a) Disconnect the G6 and G37 navigation receiver assembly connectors.

(b) Measure the resistance according to the value(s) in the table below .

Standard Resistance:

Tester Connection

Condition

Specified Condition

G6-7 (GND) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G6-4 (B) - G6-7 (GND)

Always

11 to 14 V

G6-3 (ACC) - G6-7 (GND)

Ignition switch ACC

11 to 14 V

G37-1 (IG) - G6-7 (GND)

Ignition switch ON

11 to 14 V
Text in Illustration

*a

Front view of wire harness connector

(to Navigation Receiver Assembly)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

Test yourself

A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.