Suspension

Absorber Control Switch

~1min read

Components

COMPONENTS

ILLUSTRATION

*1

ABSORBER CONTROL SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

-

-

Inspection

INSPECTION

PROCEDURE

1. INSPECT ABSORBER CONTROL SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

13 (B) - 16 (GND1)

NORMAL/CUSTOM mode switch being pushed and held

Below 1 Ω

NORMAL/CUSTOM mode switch not pushed

10 kΩ or higher

12 (P) - 16 (GND1)

SPORT S/S+ mode switch being pushed and held

Below 1 Ω

SPORT S/S+ mode switch not pushed

10 kΩ or higher

11 (ECU) - 16 (GND1)

ECO mode switch being pushed and held

Below 1 Ω

ECO mode switch not pushed

10 kΩ or higher

(1) If the result is not as specified, replace the absorber control switch (electric parking brake switch assembly).

*a

Component without harness connected

(Absorber Control Switch (Electric Parking Brake Switch Assembly))

Installation

INSTALLATION

PROCEDURE

1. INSTALL ABSORBER CONTROL SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

Click here