Brake System (Other)

Disassembly

~2min read

DISASSEMBLY

PROCEDURE

1. REMOVE END COVER

(a) Using a TORX T25 socket wrench, remove the 5 screws and the end cover.

NOTICE:

  • Hold the vacuum pump assembly so that its mating surface, other parts and the oil pipe are not damaged.
  • As the vacuum pump housing deforms when force is applied, do not hold it with a tool such as a vise.
  • Using the TORX T25 socket wrench, tighten the screws properly.
  • Do not drop the end cover.
  • Do not damage the end cover.

(b) Using a screwdriver with its tip wrapped in protective tape, remove the No. 1 O-ring.

NOTICE:

Take care not to damage the installation groove.

*a

Protective tape

2. REMOVE VACUUM PUMP VANE

(a) Remove the vacuum pump vane together with the 2 vacuum pump vane plugs.

NOTICE:

  • When reusing the vacuum pump vane and vacuum pump vane plugs, take note of their orientation and installed position.
  • Do not drop the vacuum pump vane and vacuum pump vane plugs.

(b) Remove the 2 vacuum pump vane plugs.

NOTICE:

  • When reusing the vacuum pump vane and vacuum pump vane plugs, take note of their orientation and installed position.
  • Do not drop the vacuum pump vane and vacuum pump vane plugs.

*1

Vacuum pump vane plug

*2

Vacuum pump vane